Lack of calibration option in Zigbee Curtain Module from Gladys level

Configuration
1

I connected Tuya Mini Zigbee Curtain Module QS-Zigbee-ECC02 controler for shutters. It does work, I can close/open it, even set the percentage of close of shutters. However, I cannot perform calibration from Gladys which results in percentage of closure not being accurate.
According to description of this driver it is possible to do it with home assistant, but such option is missing from gladys (I only have shutter position, state and signal strenght). Any workaround how I can induce callibration?

2

Hey @Niomak ! Welcome on Gladys :slight_smile:

Yes, you can go to the Zigbee2mqtt URL (“Integrations” → “Zigbee2mqtt” → “Configuration” → “Zigbee2mqtt URL”), and then find your Zigbee device, and you’ll be able to do the calibration there :slight_smile:

3

Thank you. That did the trick.

1 Like
4

If you have any other question on Gladys don’t hesitate :blush: